Views: 0 Author: Site Editor Publish Time: 2026-11-19 Origin: Site
Fit this element and the first thing to settle is the direction. The rubber ring in the middle faces the oil gallery.
The part in the picture is a paper oil filter. Red pleated paper forms a ring, steel caps are pressed on both ends, and a black rubber seal sits in the centre. Oil seeps through the pleats from the outside and leaves through the centre, and the dirt stays in the paper.
Why does the direction matter? With the rubber ring seated against the gallery opening, the oil has to pass through the element. If the ring is not seated, or the element goes in the wrong way round and the ring hangs in the air, the oil goes straight through the gap, and the paper is still there while nothing is being filtered. The engine does not mind losing that bit of pressure, what it needs is the filtering.
Does a black element mean replace it? Not always. Oil stains the paper by itself, and it darkening over time is normal. Judge on three things: the pleats have not collapsed, there is no metal or sludge packed into the valleys, and the rubber ring is not flattened out of shape. Collapsed pleats mean less area, metal in the valleys means something inside is wearing, a flattened ring means a leak.
When does it have to come out? Changing it with the oil at the service interval is the simplest habit. Beyond that, oil that has gone black and thin, an element that comes out with the pleats matted into one sheet, or a seal ring gone hard and springless are the cases where it does not go back in.
Which number is it? 15412-MEN-671 is the number for this element, with the CRF150R and CRF150RB on the list, and the CRF250R, CRF250X, CRF450R and TRX450R of the same line often sharing the cross reference table. Before buying, match the old element by diameter, height and the bore of the centre ring, because machines of one family do run a longer or a shorter element.