Views: 0 Author: Site Editor Publish Time: 2026-11-17 Origin: Site
This diaphragm does not pump fuel. It sits on the side of the carburetor and works another circuit.
The XR250R set is three parts: a rubber diaphragm with a brass pin in the middle, a tapered spring, and a small seal ring. Parts lists call it the air cut off valve, and it sits in that small housing on the side of the carburetor body.
What does it control? At the moment the throttle is closed, the slide shuts, the engine is still turning fast and the intake air drops away, so the mixture goes lean. Lean enough and it stops lighting cleanly, and what does not burn in the cylinder burns in the exhaust, and that is the pop. This circuit adds the fuel that the transition needs, filling in the gap as the throttle shuts. The diaphragm is the moving wall inside it, held by the spring, moving up and down to open and close the air passage.
What does a failed one look like? The commonest sign is popping on deceleration, a run of soft pops from the exhaust when you shut off from high revs or coast downhill. Next is an idle that wanders, revs that hang for a beat when you close the throttle, and fuel use that goes up. A diaphragm that has been soaked in petrol until it goes stiff, a split around the edge, or a brass pin that has worked loose, and the circuit stops doing its job.
Is popping on decel always this part? No. Rule out two cheap things first: a split in the intake boot letting air in, and exhaust joints that are not tightened down. With those cleared, open the carburetor and look at the diaphragm.
How do the three parts go in? Take the side cover off, lift the old diaphragm out, set the new one in with the brass pin facing in, drop the small seal ring into its groove, sit the spring over the pin, and put the cover back with the screws drawn down evenly, corner to corner. Do not pinch the diaphragm while fitting it, a fingernail leaves a mark that will leak.
Which number matches? 16048-KB7-901 is the number shared across several parts lists, and the XR250R is on that same list alongside the XL250R, XL500R, XR350R, XR600R, CB1000C, CB1100, FT500 and GL650. Count the carburetors on your machine and order one set for each, this is a single set.