Views: 0 Author: Site Editor Publish Time: 2026-11-17 Origin: Site
Start with the count. This machine has two carburetors, one diaphragm per carburetor, so two sets are needed when both are replaced.
Three parts in the picture: a rubber diaphragm with a brass pin through the middle, a tapered spring, and a small seal ring. The part is the air cut off valve diaphragm, and it sits in that small housing above the carburetor body on this machine. Parts listings generally describe that circuit as the one that keeps the mixture from going too lean and the exhaust from backfiring when the throttle is shut.
Why does the circuit exist? At the moment the throttle closes, the slide shuts, the engine is still spinning fast and the intake air drops away, so the mixture goes lean for an instant. Lean enough and it stops lighting properly, and the unburnt charge that reaches the exhaust is lit by the heat in the pipe, and that is the pop. This circuit adds the fuel the transition needs, filling in that gap.
What does a failed one look like? A run of pops from the exhaust while coasting downhill or shutting off from high revs is the clearest sign. After that, an idle that drifts, revs that hang for a beat as the throttle closes, and a machine that runs worse warm than cold. A diaphragm soaked stiff by petrol, a split around the edge, or a brass pin that has worked loose and the circuit stops working.
Which number is it? 43028-1085 is the number for this diaphragm, and the factory carburetor diagram shows two per machine, one in each carburetor. Do not mix it up with 16126-1226, which is the vacuum valve assembly and not this diaphragm, both appear on the same carburetor diagram but they are different parts.
What to watch when fitting? Do both carburetors together. Replacing one side only leaves the other side still stiff and the symptom comes back. Take the small side cover off, lift the old diaphragm out, lay the new one in with the pin facing in, drop the seal ring into its groove, sit the spring over the pin, and draw the screws down evenly, corner to corner. Do not pry at the diaphragm with a screwdriver tip, one scratch is one leak.