Views: 0 Author: Site Editor Publish Time: 2026-11-17 Origin: Site
A short threaded spark plug is not a broken one. It is a different job.
The E6TC is the short thread one. The thread is M14 by 1.25, the threaded length is 12.7 millimetres, and from the hex to the top of the ceramic it is about 20.8. The whole plug looks half the length of an ordinary car plug.
Why is it so short? For a two stroke. The two stroke scooter and motorcycle puts its exhaust port on the side of the barrel, and the plug has to screw into the top of it. If the thread stands out too far, it meets the piston; if it is too short, it will not seal. The short reach is built for the two stroke barrel: the tip of the electrode goes into the chamber to work, and the thread stops short of the piston.
Which machines run it? Two stroke scooters and motorcycles from 50 up to 125, plus go karts and small quads of the same kind. You do not judge by the name of the machine, you judge by the old plug: if the old one is M14 thread at 12.7 length, and the thread, the threaded length, the hex and the gap all match, it can be used.
How is it different from the E5TC? The same shape, one step different in heat range, the six is a beat colder than the five. Do not swap them carelessly. When the engine runs hot, go the colder way; when it is hard to start, go the warmer way. Check the old part and the way the engine is actually used, do not guess.
Does it replace the BP6HS, the IWF20 or the L66Y? Those are cross references of the same spec, M14 short thread for two stroke use. When replacing, check them one by one, the thread, the threaded length, the reach and the gap, and when they all match it can be used. If the old part is a pre chamber one, with the little cup on the ground electrode, do not put this plain one in its place, that is a different design.
How to fit it? Wipe the thread clean, put a thin coat of anti seize on it and screw it in, do not over tighten, the head of a two stroke is thin. The terminal nut comes with the part, that small metal piece in the picture, fit it on the terminal and tighten, and you are done.