Views: 0 Author: Site Editor Publish Time: 2026-11-17 Origin: Site
The cover is not screwed on. It is clipped on with two tabs.
The 682378-02 is the head cap on the string trimmer, the bump cap, the part that clips the line spool into the head. The cap even says how to take it off: the lettering on the rim reads press the tab to remove the cap. Press the tabs on both sides, and the cap comes off.
What does it do? The line spool and the spool spring sit inside the head, and this cap clips both of them in. When the cap works loose or a tab cracks, the spool drops out, the spring comes off, and the trimmer stops feeding line. Among the common failures of a trimmer, the cap going first is one of them.
Why is it clipped and not screwed? This kind of auto feed head is a part that gets bumped against hard things while it works, and the cap is what takes the hits. The tabs are sprung in elastic plastic, they flex under a hit instead of cracking, and a screwed part, over-tightened, is more likely to snap. That is why the cap comes off with no tool, two tabs pressed and a straight pull.
Which trimmers is it for? The ST4500 and ST5000 class of trimmers, and the RS-136 type of auto head. Other numbers are listed in places, the ST1000, ST3000 and ST4000 line, so check your old part before ordering: the size of the cap, the position of the tabs and the inside of the cap, all three should match. The older numbers 68237-02 and 6823378-02 are the same part.
Is the spring in the picture part of this? The long spring is the spool spring, it sits inside the head and holds the line spool down so the line stays wound tight. A loose spring and a cracked cap usually fail together, and it makes sense to swap them at the same time. The spring is a separate part, this one is the cap, and the spring is a separate ask.
How do you know the cap is done? A cracked tab, a cap that rattles on the head, a spool that drops out, line that will not bump feed. Any one of them is the time to swap. The cap is the impact part of the head, a worn part, and it costs far less to replace it than to take the whole head apart.